PATTERNS OF FUNCTIONAL PROPERTIES ACQUIRED BY ANTIFRICTION COMPOSITES PRODUCED FROM SILUMIN GRINDING WASTE

T.A.Roik,
 
O.A.Gavrish,
 
Yu.Yu.Vitsiuk
 

Powder Metallurgy - Kiev: Frantsevich Institute for Problems of Materials Science NASU, 2018, #09/10
http://www.materials.kiev.ua/article/2651

Abstract

The paper analyzes how the antifriction composites produced from AK12MMgN silumin grinding waste with an addition of МоS2 solid lubricant acquire their structure and porosity. The materials are intended to perform in friction joints at elevated loads of 2.0–4.0 MPa and sliding velocities of 1.0−3.0 m/s in air. It is shown how the process developed for producing these materials influences their structure and tribotechnical properties. The distribution of МоS2 in the AK12MMgN matrix composite and its role in the self-lubrication mechanism and the distribution of МоS2 and chemical elements of the friction joint in the contact zone in the sliding friction conditions corresponding to actual operation of joints in a printing machine are studied. The solid lubricant is uniformly distributed over the friction surfaces and thus covers the entire friction zone in the friction process. The tribological films formed in the presence of МоS2 solid lubricant promote high antifriction properties of the composite produced from silumin waste. These properties allow the operational modes to be improved and extend the application of new wear-resistant materials produced from recycled resources in contact joints of printing machines.


ANTIFRICTION MATERIAL, COMPOSITE MATERIALS, FRICTION FILM, GRINDING WASTE, JOINTS OF PRINTING MACHINES, SILUMIN, SOLID LUBRICANT, TECHNOLOGY, WEAR RESISTANCE